Basic dialogue format
Dialogue in a screenplay is made of up to three pieces, stacked in this order:
- The character name, in capital letters, indented toward the center of the page
- An optional parenthetical, on its own line
- The speech, in a narrower block than the action lines
DANA
I told you I'd be here.
MARCUS
(not looking up)
You also told me you'd be here on time.
There are no quotation marks around dialogue. Lines are single-spaced, and a blank line separates one speaker’s block from the next. Screenwriting software places the indents for you. The approximate default indents measured from the left edge of the page are about 2.5 inches for dialogue, about 3.1 inches for parentheticals and about 3.7 inches for character names, but values vary by program.
Keep the character’s name the same every time. If a character is introduced as MARCUS and later appears as MARC, a reader may wonder whether those are two people. See how to introduce a character for naming at first appearance.
Parentheticals
A parenthetical is a short direction in parentheses under the character name. It can show how a line is delivered, who is being addressed, or a tiny action in the middle of speech.
Use parentheticals sparingly. If the tone is clear from the line and the context, leave it out. Typical good uses:
- Clarifying who is being spoken to in a group scene:
(to Marcus) - A small beat of action that fits within the line:
(beat) - Sarcasm or irony that the line would not make clear on its own
They should be brief, lowercase, and fit on one line when possible. A page full of parentheticals can read as over-directing the actor.
Extensions
An extension is a short note after the character name, in parentheses, that explains how the voice is heard. The common ones:
(V.O.)for voice-over, when the speaker is not in the scene(O.S.)for off-screen, when the speaker is in the scene’s location but not visible(O.C.)for off-camera, used by some writers in a similar way to O.S.(CONT'D)for continued, when the same character speaks again after an action line interrupts
NARRATOR (V.O.)
The summer everything changed started quietly.
The differences between these are covered in V.O. vs O.S. vs O.C.. For a phone voice, see how to write phone calls and text messages.
CONT’D and MORE
When a single character speaks, then an action line interrupts, then the same character speaks again, many scripts add (CONT'D) to the second name. Screenwriting software typically inserts this automatically. When a long speech must break across a page, the program may add (MORE) at the bottom of the first page and NAME (CONT'D) at the top of the next. Not every writer or reader cares about CONT’D, so follow your software’s behavior unless a submission guideline says otherwise.
Dual dialogue
Dual dialogue is when two characters speak at the same time. The two speeches are placed side by side on the page, each in its own column.
Final Draft and most other screenwriting programs have a dual dialogue command that does the layout for you. In a word processor, a two-column table without borders is the usual workaround, though it is easier to use a screenwriting program for this. Use it sparingly. Overlapping speech is easier to read as a line of action, such as “They talk over each other,” or by ending one line with a dash and starting the next, which suggests an interruption.
Dialogue interrupted by action
If a character does something in the middle of a speech, split the dialogue into two blocks with an action line between them:
DANA
I told you I'd be here.
She sets the keys on the counter.
DANA (CONT'D)
And I am.
For describing the action in that middle paragraph, see how to write action lines.
Common mistakes
- Using parentheticals on most lines
- Writing long speeches without any breaks or action
- Putting dialogue in quotation marks
- Mixing different spellings of a character’s name
- Forgetting extensions where a voice is heard but not seen
The complete screenplay format guide shows how dialogue fits with the other elements on the page. For what your characters actually say, see how to write great screenplay dialogue.